Vertical Rod Support Caps
21
Likes
172
Downloads
1163
Views
Published on November 20, 2012
Description
The vertical bearing rods on my Replicator wiggled a bit. I made these caps to hold the rods still. I figure stiffness = better prints.
Instructions
No instructions provided.
You must be logged in to post a comment.
Collections
Tests and setup
by camstuff
Bot Improvements
by andyways
Replicator Upgrades - Motion Mechanics
by garyacrowellsr
License
Vertical Rod Support Caps by sceadu_design is licensed under the Attribution - Share Alike - Creative Commons license.
More from sceadu_design
More from 3D Printer Accessories
Looks good. I'll install these when I do the XL rebuild.