RobCo Processor Widget from Fallout 3
2
Likes
100
Downloads
496
Views
Published on November 20, 2012
Description
Moira Brown will give it to you and asks you to insert it in the mainframe of the RobCo Facility.
All I had to go by was the black and white drawing from the Wiki. I think i did pretty well.
For somereason the photos don't show the right way up.
All I had to go by was the black and white drawing from the Wiki. I think i did pretty well.
For somereason the photos don't show the right way up.
Instructions
Both parts are fine details. The Widget I think I did .2mm layer, 25% infil and 0 shells.
The Widget inside since since it is only 1mm thick. I did .2mm Layer, 100% fill, and 0 shells. (It took 15 minutes to print the inside)
Once done, do a small amount of clean up around the single hole on the bottom of the inside, then just press it into the main body.
The Widget inside since since it is only 1mm thick. I did .2mm Layer, 100% fill, and 0 shells. (It took 15 minutes to print the inside)
Once done, do a small amount of clean up around the single hole on the bottom of the inside, then just press it into the main body.
License
RobCo Processor Widget from Fallout 3 by TCorgard is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.