Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Ians Ultimate Ultimaker Cooling Fan Shroud
22
Likes
482
Downloads
2904
Views
Published on November 22, 2012
Description
Ians Ultimaker Cooling Fan Shroud
something i am cooking up, that will click onto the right or left side of the ultimaker hot end and need no screws, bolts or washers.. reducing weight on the head.
Ian
something i am cooking up, that will click onto the right or left side of the ultimaker hot end and need no screws, bolts or washers.. reducing weight on the head.
Ian
Instructions
Ians Ultimate Ultimaker Cooling Fan Shroud
something i am cooking up, that will click onto the right or left side of the ultimaker hot end and need no screws, bolts or washers.. reducing weight on the head.
Ian
.....................
update 28.11.2012
updated design.
.....................
printed
speed 80
temp 210
layer .1
no rafting and no supports ( supports are already in the model file )
......................
the latest design is much quicker to fit now and also has a really good air flow target.
something i am cooking up, that will click onto the right or left side of the ultimaker hot end and need no screws, bolts or washers.. reducing weight on the head.
Ian
.....................
update 28.11.2012
updated design.
.....................
printed
speed 80
temp 210
layer .1
no rafting and no supports ( supports are already in the model file )
......................
the latest design is much quicker to fit now and also has a really good air flow target.
You must be logged in to post a comment.
engrkris
on
December 19, 2012
said:
In your photo with the dual fans, it looks like the fans are a bit bigger than the original. Are those 50mm ? I'm assuming you just wired them in parallel and connected to the original plug ?
funbart
on
November 25, 2012
said:
funny,
I made a kind of clip-ons for the replicator to redirect the airflow, also in ArchiCad! http://www.thingiverse.com/thi...
At the end you can do a lot in ArchiCad when you are used to it. I don't think a lot of people are using it though..
Bart
yzorg
on
November 23, 2012
said:
though about putting an extra airpath that goes inbetween woodplate and aluminium. aka. coldend.
License
Ians Ultimate Ultimaker Cooling Fan Shroud by ultimakerinleipzig is licensed under the Attribution - Share Alike - Creative Commons license.
More from ultimakerinleipzig
More from 3D Printer Parts
Hi, does this fan shroud design is compatible with the hotend v2 ?