GT2 Belt Clamp For Ecksbot
2
Likes
386
Downloads
1063
Views
Published on November 22, 2012
Description
Would you like to use GT2 belts on your Ecksbot for reduced backlash in the X and Y axis?
Heck ya!
Print these clamps and use them in place of the standard Ecksbot belt-clamps.
POOF!
Your Ecksbot is GT2 ready! :)
/* This is derived from some other folks hard work to "parameterize" RepRap belt clamps. The ancestry of this design can be traced back to Josef Prusa's belt-clamps :)
Heck ya!
Print these clamps and use them in place of the standard Ecksbot belt-clamps.
POOF!
Your Ecksbot is GT2 ready! :)
/* This is derived from some other folks hard work to "parameterize" RepRap belt clamps. The ancestry of this design can be traced back to Josef Prusa's belt-clamps :)
Instructions
1.Download
2.Slice
3.Print
4.Clamp!
2.Slice
3.Print
4.Clamp!
License
GT2 Belt Clamp For Ecksbot by idolcrasher is licensed under the Attribution - Creative Commons license.
More from idolcrasher
More from 3D Printer Parts
You must be logged in to post a comment.