Merry Christmas Professor Koch!
42
Likes
1657
Downloads
3224
Views
Published on November 22, 2012
Derived from
Koch Snowflake Vase 1
by sphynx
Description
A Christmas tree made of Koch Snowflakes (iteration 3).
Instructions
To print out the tree, print the following files:
1to2Tree.stl.
3to7Tree.stl
treeTrunk.stl
My Cura settings are in the JPEG. I used 20% fill.
When you assemble the tree, be aware that the holes in each layer have the same taper as the trunk. So the layers fit much better one way up than the other. In fact, they should sort of click into place because of the matching tapers.
If you want to play about with the Koch Snowflakes, I have also uploaded the DXF and SCAD files. For instructions see the featured thing thingiverse.com/thing:35246
1to2Tree.stl.
3to7Tree.stl
treeTrunk.stl
My Cura settings are in the JPEG. I used 20% fill.
When you assemble the tree, be aware that the holes in each layer have the same taper as the trunk. So the layers fit much better one way up than the other. In fact, they should sort of click into place because of the matching tapers.
If you want to play about with the Koch Snowflakes, I have also uploaded the DXF and SCAD files. For instructions see the featured thing thingiverse.com/thing:35246
You must be logged in to post a comment.
License
Merry Christmas Professor Koch! by sphynx is licensed under the Attribution - Share Alike - Creative Commons license.
Very cool, plated all at the same time on a Replicator (Printed 1 of each.. Red,White,Green). Printed 10% infill, 2 shells (1 in Print-o-matic). I think 1 shell would've worked better as there's a little bit missing at the tip of each snowflake.
Great looking!