Zing Pen Tool
1
Likes
99
Downloads
599
Views
Published on November 23, 2012
Description
This is a pen tool holder for the KNK Zing machine.
Instructions
Print and then tap the hole. The set screw is plastic one you can get from the hardware store.
You must be logged in to post a comment.
SteveC
on
November 23, 2012
said:
The second version is with a bit of a base that is 3 layers.
My 3d printer (Airwolf3D) had a problem of banana boat and the part came off the plate. Enjoy.
SteveC
on
November 23, 2012
said:
This tool was measured by me. I used calipers and some guessing to the precision. I am by far no good designer. I then used freecad to create the part you see here. This is my first part.
License
Zing Pen Tool by SteveC is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from Machine Tools
Just added a new photo of the one I printed that worked. 2nd file at 97kb. The bottom extra was peeled off by hand. I had added it due to the part coming off the plate. The hole was also made smaller and is on the other side in the photo.