Snowflake Cookie Cutter
14
Likes
297
Downloads
1122
Views
Published on November 23, 2012
Description
A snowflake cutter. Designed for making snowflake soaps, it's also fine for cookies. I also made a thing for pushing the soap/dough out of the cutter if it gets stuck inside. It saves a lot of time over poking it out with a q-tip or something.
Instructions
If you print with .35 extrusion width, the walls will be 2 perimeters wide. I don't recommend using Slic3r 09x, it didnt' make a steady, unbroken toolpath for the walls. The print shown was done with KISSlicer.
I recommend printing in ABS and smoothing with acetone. That will bond the layers together on the walls for extra strength, especially the edge. The two threads of the edge might be prone to splitting apart otherwise. I used the Presto Part Finisher from Walmart - solidoodletips.wordpress.com/2012/11/10/presto-part-finisher/
Here is a video of it in action making Snowflake soaps for a school fundraiser.
youtu.be/9nd59afVuRY
I recommend printing in ABS and smoothing with acetone. That will bond the layers together on the walls for extra strength, especially the edge. The two threads of the edge might be prone to splitting apart otherwise. I used the Presto Part Finisher from Walmart - solidoodletips.wordpress.com/2012/11/10/presto-part-finisher/
Here is a video of it in action making Snowflake soaps for a school fundraiser.
youtu.be/9nd59afVuRY
More from ianjohnson
More from Kitchen & Dining
You must be logged in to post a comment.