Sort By
mag coupling.stl
1 mb /
97 downloads /
2 years ago
4.8ID mag coupl.stl
1 mb /
87 downloads /
2 years ago
6.35ID mag coupl.stl
1 mb /
88 downloads /
2 years ago
They Like It
Magnetic coupling by Chooch is licensed under the Attribution - Creative Commons license.
© 2010 by Chooch
Instructions
-Print out couplings and trim ( prints two at a time )
-Insert magnets in attraction or repulsion to the other coupling. Magnets will press fit in, but you can use glue or put tape over them to hold them in place.
-Put couplings on shaft, and use an M3 set screw or screw to hold them on.
-Roughly align the couplings and move them in close to each other.
-Now you have two shafts magnetically coupled, without the headache of axially aligning them! :)
