by Schorhr, published
I wonder if anyone remembers the green phone with cord.
EVERYBODY had it back when our phone company still had the state monopol.
I really should make a older version with a working phone dial.
Unfortunately the one in the picture was printed "phone side down", resulting in the spaker-holes not to show.
It's best printed on the side for higher detail (but cord will be less stable).
You could print it standing up to avoid support material on the cord loops. Also, standing coils/springs tend to be a bit more stable due to layer orientation(see spring earring).
PS: The model is not one shell, as usual, this was a daily-earring and therefore quick&dirty. It can cause some problems at the cord where the pieces join. You may want to check it (run it through meshlab/netfabb/etc.).
This one was done April-2011 and is one of the many earrings I have not uploaded for some reason.
I just discovered this due to the fact one of them broke and I went back to reprinting the model, checking Thingiverse for info on settings and orientation.
Liked ByView All
Give a Shout Out
Telephone earring by Schorhr is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving Schorhr a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Schorhr would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).