Replicator filament tube support bracket
4
Likes
101
Downloads
714
Views
Published on November 24, 2012
Description
My filament tube holders on the back was busted and so i needed something to replace them with.
The filament tube holders i found on Thingiverse all relied on the original plastic holders still being in place so i designed a new "all in one" bracket.
The filament tube holders i found on Thingiverse all relied on the original plastic holders still being in place so i designed a new "all in one" bracket.
Instructions
Print, remove the tube holders on the back of the Replicator, put the bracket in place, add a couple of zip ties and your good to go!
License
Replicator filament tube support bracket by barspin is licensed under the Attribution - Creative Commons license.
More from barspin
More from 3D Printer Parts
You must be logged in to post a comment.