Koch Snowflake Candy Dish
12
Likes
156
Downloads
1736
Views
Published on November 24, 2012
Description
So in the Christmas spirit of turning everything into a Koch Snowflake, the wifey wanted something to put the little Christmas candies in, and I wanted to play with OpenScad. Here's the compromise - a twisted scaled Koch Snowflake!
Instructions
Print in your favorite colors - I'm using this one to clean up the bits and pieces of filament I have lying around. Use the normal slicing tricks to make it a vase - I used .4mm layers and 3 loops since she who must be pleased needed one "right NOW!".
I've not got any flickering LED's lying around, but I think it would make an entertaining LED lamp as well!
The candy dish is about 100mm x 50mm, and should scale if required.
I've not got any flickering LED's lying around, but I think it would make an entertaining LED lamp as well!
The candy dish is about 100mm x 50mm, and should scale if required.
License
Koch Snowflake Candy Dish by SystemsGuy is licensed under the Attribution - Share Alike - Creative Commons license.
More from SystemsGuy
More from Containers
The STL has no "void" in the middle. It is solid!!
Correct - cuts way down on the processing time in OpenSCAD, and gives you much more flexability on the wall & base thickness.
In your slicer, simply tell it to do no infill - that will make it hollow - and then tell it how many top and bottom layers you want. In my case, I did 3 bottom layers, no top layers, and used 3 perimeter loops.