Support Jig for Compression Test
0
Likes
61
Downloads
444
Views
Published on November 25, 2012
Description
This is a jig to ensure your test sample doesn't buckle during a material sample compression test.
Instructions
Print two jig pieces
Sandwich sample between two jig pieces with teeth on sample
Insert a bolt in each bolt hole with one washer (4 bolts and 4 washers total)
Add 4 more washers on the opposite side
Thread 4 wingnuts (or nuts if you prefer) and lightly tighten (finger tight)
Install entire setup to Load Machine.
Have fun breaking things! :D
Sandwich sample between two jig pieces with teeth on sample
Insert a bolt in each bolt hole with one washer (4 bolts and 4 washers total)
Add 4 more washers on the opposite side
Thread 4 wingnuts (or nuts if you prefer) and lightly tighten (finger tight)
Install entire setup to Load Machine.
Have fun breaking things! :D
License
Support Jig for Compression Test by tbm0115 is licensed under the Attribution - Share Alike - Creative Commons license.
More from tbm0115
More from Machine Tools
You must be logged in to post a comment.