Printable secondary extruder plate for ultimaker
by kwatts, published
This is a printable extruder plate for the ultimaker.
I really like Jelle's 4 extruder plate, but the local hackspaces do not have a laser capable of cutting the 6mm plywood.
This solves my problem of where to put the second extruder.
I made it a tiny bit wider that the laser cut ones so they will fit a printed extruder.
Recent Commentsview all
Liked Byview all
Give a Shout Out
This sits on top of the far right bearing cap. You will also need to drill 2 holes in the back of your ultimaker.
bom: 4 20mm x 3mm screws 2 3mm nuts 2 * 3mm washers
cura slicing settings:
0.2 layers .6 wall & top/bottom thickness
I printed this with 30% hexagonal IMPLA from Diamond age. Other wise i would use 60%