Desk Leg Cable Clip
1
Likes
108
Downloads
418
Views
Published on November 25, 2012
Description
This clip is meant to clip onto the leg of the desk like the one shown in the attached picture. It holds the usb cable plugged into the front port up within easy reach and out of harms way of the chair wheels.
Instructions
I printed this in PLA using these settings, it came out nice and flexible.
; generated by Slic3r 0.7.2b on 2012-11-24 at 22:17:35
; layer_height = .3
; perimeters = 3
; solid_layers = 3
; fill_density = .4
; nozzle_diameter = 0.4
; filament_diameter = 3
; extrusion_multiplier = .9540
; perimeter_speed = 30
; infill_speed = 60
; travel_speed = 130
; extrusion_width_ratio = 0
; scale = 1
; single wall width = 0.42mm
; generated by Slic3r 0.7.2b on 2012-11-24 at 22:17:35
; layer_height = .3
; perimeters = 3
; solid_layers = 3
; fill_density = .4
; nozzle_diameter = 0.4
; filament_diameter = 3
; extrusion_multiplier = .9540
; perimeter_speed = 30
; infill_speed = 60
; travel_speed = 130
; extrusion_width_ratio = 0
; scale = 1
; single wall width = 0.42mm
License
Desk Leg Cable Clip by Leary is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.