Towel Holder
11
Likes
146
Downloads
377
Views
Published on November 25, 2012
Description
I was tired of my old towel holder inside the bathroom cabinet so I decided to build one using OpenSCAD so I could easily tweak the design later.
Instructions
Just print the two STL files (no need for Raft/Support). On my Replicator 1, I used PLA at 15 % infill (.25 mm layer height, 1 shell) which made it strong enough for daily usage.
If I have time, I might tweak the bar so that the two prongs enter horizontally instead of with an angle, because it wiggles a little bit but nothing serious.
2013-03-02: Added version 2 to make the prongs stronger...
If I have time, I might tweak the bar so that the two prongs enter horizontally instead of with an angle, because it wiggles a little bit but nothing serious.
2013-03-02: Added version 2 to make the prongs stronger...
License
More from Bathroom
You must be logged in to post a comment.