Simple between frame Y-rod mounts for MendelMax
by BlazakoV, published
Simplified version of NM-Buzzard's design. For 8mm,10mm and 12mm rods.
Printed, tested, works fine.
For more info see original:
UPDATE: Added 12mm version
Choose your rods size and print 4. Place parts between extrusions, screw them loosely, insert rods and heatbed, check distances (caliper is recommended) and tighten screws.
-"Short" hex key 3*
-(8) M5 x 10 screws
-(8) M5 washers
*Following original instructions:
"Because of the tight confines inside the mount, it is required to have a "stubby" hex key to tighten the frame mounting screws. I simply cut an extra one I had down to about 5mm."
Liked ByView All
Give a Shout Out
Simple between frame Y-rod mounts for MendelMax by BlazakoV is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving BlazakoV a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure BlazakoV would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).