Snowflake Champagne glass
20
Likes
321
Downloads
1767
Views
Published on November 25, 2012
Derived from
Traced Snowflake
by Landru
Description
A Champagne glass with a snowflake as a foot. I also added a second glass with a regular foot.
Instructions
I printed one in dualtone. I didn't have any white filament which would have looked nice, so i printed the bottom in yellow and the glass in transparent blue.
I will shorten the stem and make the bowl a bit taller. Not quite satisfied yet. Like the regular one a bit better.
Thanks to Landru for the nice traced snowflake.
About 30mm/s works best for the foot and stem. the bowl can be printed at 100 mm/s.
I will shorten the stem and make the bowl a bit taller. Not quite satisfied yet. Like the regular one a bit better.
Thanks to Landru for the nice traced snowflake.
About 30mm/s works best for the foot and stem. the bowl can be printed at 100 mm/s.
You must be logged in to post a comment.
More from casentim
More from Kitchen & Dining
Thank you for these designs! It slices perfectly in Slic3r 0.9.7 and prints very well (water tight.) My family enjoyed a novelty Christmas with your help.