Mobile Phone Stand
5
Likes
434
Downloads
1218
Views
Published on November 25, 2012
This thing can be customized with MakerBot Customizer!
Open in Customizer
Description
Universal Mobile Phone Stand
Made with openscad
Made with openscad
Instructions
Print on its side to prevent using support.
You must be logged in to post a comment.
KingHelps
on
November 30, 2012
said:
It's pretty big! What phone did you have in mind for this?
frankkienl
on
December 4, 2012
said:
I have printed the design.
It took about 2 hours and 30 minutes.
And yes, it is very big.
But the phone stand is the correct size for holding a phone.
It is almost identical to a real, metal, phone stand.
frankkienl
on
November 30, 2012
said:
It is supposed to hold a Samsung Galaxy S3 in Landscape.
But I have no idea if it will work.
I have no 3D printer yet.
The phone is like 140mm long, the stand is like 80mm wide, so it should be smaller than the phone.
(==[stand]==)
License
Mobile Phone Stand by frankkienl is licensed under the Attribution - Share Alike - Creative Commons license.
More from frankkienl
More from Mobile Phone
Tried to alter Front Length in Customizer, but tray stays at same height (62mm).
I made a new version, this one should work better in the customizer.
Thanks for the feedback !
http://www.thingiverse.com/thi...
You are right.. that should not happen..
I think it will take some time to fix that.
For now you can use this:
http://www.thingiverse.com/thi...
I'll reply to you again when I have a fix for the problem ;-) !