T2,5 32 teeth Pulley UPDATED, (equivalent size to GT2 40 teeth for Rostock)
14
Likes
348
Downloads
1642
Views
Published on November 25, 2012
Description
I'm about to build up the great Rostock concept:
thingiverse.com/thing:17175
as T2,5 timing Belts are much more available for me than the GT2, I was looking for a pulley with a matched size, so the original configurations can be used. As i couldn't find one, I calculated it, and made one.
Update: I Changed the teeth-structure, should give a better grip. Feel free to inform about problems in size or grip etc.
thingiverse.com/thing:17175
as T2,5 timing Belts are much more available for me than the GT2, I was looking for a pulley with a matched size, so the original configurations can be used. As i couldn't find one, I calculated it, and made one.
Update: I Changed the teeth-structure, should give a better grip. Feel free to inform about problems in size or grip etc.
Instructions
needed:
2 M3 Nuts
2 M3x15 Screws (M3x10 Mud screws could also be used, just screw them through with a thin enough screw driver)
skp file also upped, for those who have better 3d-drawing skills to optimize it, or adjust i.e. the nut trap holes
2 M3 Nuts
2 M3x15 Screws (M3x10 Mud screws could also be used, just screw them through with a thin enough screw driver)
skp file also upped, for those who have better 3d-drawing skills to optimize it, or adjust i.e. the nut trap holes
License
T2,5 32 teeth Pulley UPDATED, (equivalent size to GT2 40 teeth for Rostock) by Petehagoras is licensed under the Attribution - Creative Commons license.
More from Petehagoras
More from 3D Printer Parts
You must be logged in to post a comment.