MendelMax Power Supply Mounting Brackets
12
Likes
267
Downloads
1142
Views
Published on November 26, 2012
Description
I needed power supply mounting brackets for a MendleMax 3D printer.
The 12 volt power supply for my MendleMax 3D printer is 113mm wide with two sets of 4mm taped holes (top and bottom) on one side and one set of 4mm taped holes (at the bottom) on the other side. The 3D printer frame width is 260mm on the inside where a 5mm screw can fasten to the aluminum extrusion inserts.
The 12 volt power supply for my MendleMax 3D printer is 113mm wide with two sets of 4mm taped holes (top and bottom) on one side and one set of 4mm taped holes (at the bottom) on the other side. The 3D printer frame width is 260mm on the inside where a 5mm screw can fasten to the aluminum extrusion inserts.
Instructions
Print two each of the brackets for ease of assembly. Also print a set of Feet to elevate the printer.
License
MendelMax Power Supply Mounting Brackets by DR2D is licensed under the Attribution - Share Alike - Creative Commons license.
More from DR2D
More from 3D Printer Parts
You must be logged in to post a comment.