MP-25 Raven Replacement Grips
by Relentless, published
These are a pair of replacement grips for a MP25 Handgun. The ones my client wanted replaced had become badly warped due to the high humidity levels here in the south,and the gun is apparently rather archaic and replacement hardware is both rare and relatively costly, so he wanted a plastic replacement that would hold up better.
These grips were design to be reproduced using ABS, as the design accounts for the shrinkage of the ABS.
Print 1 each of the replacement grips, using ABS. I used 1 extra shell on the prints. The infill is negligibly important as most of the grip is filled no matter the infill percentage.
WARNING: Following safe firearm handling practices remove any ammunition from the firearm.
Remove the old grips by removing the screws from each grip. Retain the screws to reinstall the new grips.
- Install the new grips using the old hardware. Note that minor hand finishing may be required to obtain a proper fit.
Liked ByView All
Give a Shout Out
MP-25 Raven Replacement Grips by Relentless is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving Relentless a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Relentless would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).