30mm M8 rounded Idler washer (Rostock)
3
Likes
216
Downloads
642
Views
Published on November 26, 2012
Description
Had problems because the timing belt kinda hoped on the regular 30mm washer beside the bearing because of the 2° tilt of the Rostock-Idler so it didn't run smooth. This very simple printed washer absolutely made it. Could shurely be used for other printers aswell.
Instructions
Print, mount, finished.
I'd recommend to put a regular small M8 washer between bearing and rounded washer, to keep the bearing turning while the carrying screw/rod is well fastened
I'd recommend to put a regular small M8 washer between bearing and rounded washer, to keep the bearing turning while the carrying screw/rod is well fastened
License
30mm M8 rounded Idler washer (Rostock) by Petehagoras is licensed under the Attribution - Creative Commons license.
More from Petehagoras
More from 3D Printer Parts
You must be logged in to post a comment.