MendelMax Undercarriage PSU Mount
8
Likes
448
Downloads
1187
Views
Published on November 27, 2012
Description
This allows you to mount your PSU’s under a standard height MendelMax without increasing the height of the MendelMax.
This is of course assuming you have enough clearance for the print bed to move.
This is of course assuming you have enough clearance for the print bed to move.
Instructions
Print out one set(one of each of the 3 parts) of parts.
Attach to the PSU
Mount to MendelMax frame with 5mm screws & T Nuts.
You dont need to use every hole to mount but you can if you want.
Hope this helps somone out there.
Attach to the PSU
Mount to MendelMax frame with 5mm screws & T Nuts.
You dont need to use every hole to mount but you can if you want.
Hope this helps somone out there.
License
MendelMax Undercarriage PSU Mount by Dwadia is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from Dwadia
More from 3D Printer Parts
You must be logged in to post a comment.