Boltless spool holder
23
Likes
357
Downloads
1658
Views
Published on November 27, 2012
Description
I didnt have any bolts and needed a spool holder right away so I designed this.
You need four 608 bearing.
I have been using this for months with spools from Ultimachine and repraper
You need four 608 bearing.
I have been using this for months with spools from Ultimachine and repraper
Instructions
-Print 1 frame
-Print 4 Pins
-Inser the pins in the frame
-Insert a 608 bearing on each pins
-Place a plastic washer on the end of each pins
-Use a peice of 3mm filament in the hole of the pins to lock it all in place
I suggest glueing rubber feets underneat the frame so it doesnt slide on the table.
-Print 4 Pins
-Inser the pins in the frame
-Insert a 608 bearing on each pins
-Place a plastic washer on the end of each pins
-Use a peice of 3mm filament in the hole of the pins to lock it all in place
I suggest glueing rubber feets underneat the frame so it doesnt slide on the table.
License
Boltless spool holder by thecrazy is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from thecrazy
More from 3D Printer Accessories
Welcome :)