Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Photoduino Box
7
Likes
225
Downloads
2038
Views
Published on November 28, 2012
Description
Enclosure for the Photoduino Board version 3 with space for Arduino UNO. versions for Lithium Pack from Liquidware and 9V battery
Instructions
The file "Photoduino_Box_Li" is for use with a Liquidware Lithium Pack Battery, the file "Photoduino_Box_9V" is for use a 9 Volt battery
I use 3 mm acrilic (or MDF), cut with laser.
snap the parts with your board, you need the following Allen screws:
all in 3 mm of diameter.
4 of 12 mm long (for the LI version)
4 of 25 mm long (for the 9V version)
2 of 20 mm long
8 of 16 mm long
14 of 8 mm long
use the corner small pieces to ensamble, the odd pieces is for ajust the board.
The instrucction are on progress.
I use 3 mm acrilic (or MDF), cut with laser.
snap the parts with your board, you need the following Allen screws:
all in 3 mm of diameter.
4 of 12 mm long (for the LI version)
4 of 25 mm long (for the 9V version)
2 of 20 mm long
8 of 16 mm long
14 of 8 mm long
use the corner small pieces to ensamble, the odd pieces is for ajust the board.
The instrucction are on progress.
You must be logged in to post a comment.
El_Pop
on
November 28, 2012
said:
If you want one alredy ensambled, i can sold to you the shield. I sold only in Mexico right now, but i can send you to US.
AndyChuck
on
November 28, 2012
said:
I've been looking for a complete Photoduino kit for months. Do you happen to know where I can get one in the US?
Thanks..Great box too!
License
Photoduino Box by El_Pop is licensed under the Attribution - Share Alike - Creative Commons license.
More from DIY
I sent you an email, I would like for you to get me a price for a completed kit, your new case included.
Thanks