Downloads
Sort By
MendelPawFoot.blend
160 kb /
80 downloads /
2 years ago
MendelPawFoot.stl
40 kb /
89 downloads /
2 years ago
They Like It
Mendel Paws by smwombat is licensed under the Attribution - Creative Commons license.
© 2010 by smwombat
Instructions
Print 4 paws - you might need to flip them over first, I made them this way so they would print with RepSnapper.
Print 4 y-bar-clamps. Attach to Mendel frame. I screwed the paws on using sheet metal screws, but I think you could pressure fit standard hex cap screws. (I wanted to put the paws facing 'out'from the side, but my electronics are in the way).
