Crown Of Polygonia
18
Likes
136
Downloads
859
Views
Published on November 28, 2012
Description
Crown Of Polygonia
size it for what you want to put one on.
I used tinkercad to make the bulk of this, I did the tips over in truespace
here is the tinkercad model if you want to "tinker around" with it.
tinkercad.com/things/6wwRCifh6ul-crown
size it for what you want to put one on.
I used tinkercad to make the bulk of this, I did the tips over in truespace
here is the tinkercad model if you want to "tinker around" with it.
tinkercad.com/things/6wwRCifh6ul-crown
Instructions
I did a test print with the following settings
in PLA.
0% infill
1 shell
230 degrees extruder
.27 slice
80mm/sec replicator accelerated settings
I would recomend 2 shells or 3 no infill
the print I did (Pictured on replicator) at 1 shell was very light but
too fragile.
I did a print with 2 shells and it is considerably more solid.
of course if you are making a smaller print, 2 shells might be overkill.
in PLA.
0% infill
1 shell
230 degrees extruder
.27 slice
80mm/sec replicator accelerated settings
I would recomend 2 shells or 3 no infill
the print I did (Pictured on replicator) at 1 shell was very light but
too fragile.
I did a print with 2 shells and it is considerably more solid.
of course if you are making a smaller print, 2 shells might be overkill.
License
Crown Of Polygonia by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from Accessories
You must be logged in to post a comment.