Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
SFX to ATX adaptor plate
1
Likes
95
Downloads
730
Views
Published on November 29, 2012
Description
This plate allows an SFX PSU to be mounted in the hole for an ATX PSU.
Instructions
Print the plate.
Drill out the inner 3 holes with a 0.138 inch diameter drillbit.
Tap the outer 4 holes with a 6-32 tap. (I've found taping is unecessary)
Assemble!
This plate is modified from stock SFX to match "CIT Micro Atx Power Supply". Stock SFX needs a width of 100, not 125.
I've added reinforcing ridges around the outside.
Drill out the inner 3 holes with a 0.138 inch diameter drillbit.
Tap the outer 4 holes with a 6-32 tap. (I've found taping is unecessary)
Assemble!
This plate is modified from stock SFX to match "CIT Micro Atx Power Supply". Stock SFX needs a width of 100, not 125.
I've added reinforcing ridges around the outside.
You must be logged in to post a comment.
License
More from hdonk
You should consider grounding the case to the power supply. The case or shell of the PSU is grounded and should be touching the case in some fashion for saftey and emf protection.
Thanks, that's a good point.
Although the case and CPU are grounded through the motherboard.
And in this chassis, the IEC extension lead includes a link to ground the case.
But if that wasn't present, then yes, an additional link would be required.