Extruder Cable Guide
7
Likes
229
Downloads
985
Views
Published on November 29, 2012
Description
This is a quick little bracket for fixing the extruder cables to the stepper motor using cable ties. The bracket can be mounted vertically or horizontally using cable ties and again the cable is held in with two more cable ties.
Instructions
Print it ;-)
Fix the bracket to the motor using two 5mm cable ties either horizontally or vertically using the two tabs that stick out from the sides.
Run your cables through the guide and use two small 3mm cable ties in the two slots to hold it in place.
There is a second version (cable guide II.stl) with a single bolt hole that I used to mount on the X-End so the cable loops around to the side.
Fix the bracket to the motor using two 5mm cable ties either horizontally or vertically using the two tabs that stick out from the sides.
Run your cables through the guide and use two small 3mm cable ties in the two slots to hold it in place.
There is a second version (cable guide II.stl) with a single bolt hole that I used to mount on the X-End so the cable loops around to the side.
License
More from Stu_Dkn
More from 3D Printer Extruders
You must be logged in to post a comment.