Torch Pocket Hanger
7
Likes
177
Downloads
728
Views
Published on November 30, 2012
Derived from
Pocket Hanger
by paulhoover
Description
This allows a 2mm diameter cord to be attached to an EDC torchlight. The Torch Pocket Hanger "hangs" to to your pocket and allows quick access to your torchlight.
Instructions
Built mine using Makerbot Rep2 with 0.2mm layers.
No supports required.
** Updated with TPHv2.stl
The first one was too loose, added a semi-circle extrusion on the clip for more grip. Also lengthened the clip.
Reduced the thickness of the clip, somehow the clip portion became hollow and had an added spring effect :)
** Updated with TPHv7 assy.stl
This makes use of a small spring from a mini wooden clothespin.
Made this major change as the PLA keeps getting out of shape and looses grip.
** Updated with TPHv9 Assy.stl
Updated the design so that the spring will stay in place.
This should be the final update :)
No supports required.
** Updated with TPHv2.stl
The first one was too loose, added a semi-circle extrusion on the clip for more grip. Also lengthened the clip.
Reduced the thickness of the clip, somehow the clip portion became hollow and had an added spring effect :)
** Updated with TPHv7 assy.stl
This makes use of a small spring from a mini wooden clothespin.
Made this major change as the PLA keeps getting out of shape and looses grip.
** Updated with TPHv9 Assy.stl
Updated the design so that the spring will stay in place.
This should be the final update :)
License
Torch Pocket Hanger by ark19 is licensed under the Attribution - Non-Commercial - Share Alike license.
You must be logged in to post a comment.