Makey_Makey case (Snap together)
11
Likes
123
Downloads
680
Views
Published on December 1, 2012
Description
Makey_Makey case
Instructions
Place your Makey_Makey on to the base and align the USB connector with the slot provided. The connectors on the base should slot into the rectangular holes on the base. Snap the end caps onto the base - these should now hold the Makey_Makey securely in place.
I printed mine out with a 33% fill which seemed to work fine. Also, try and print the end caps a different colour to the base - it'll look nicer :)
Lastly, big thanks to the Makey_Makey team for this canny bit of hardware.
I printed mine out with a 33% fill which seemed to work fine. Also, try and print the end caps a different colour to the base - it'll look nicer :)
Lastly, big thanks to the Makey_Makey team for this canny bit of hardware.
You must be logged in to post a comment.
License
Makey_Makey case (Snap together) by ResRobin is licensed under the Attribution - Creative Commons license.
More from Electronics
I didn't know what one of these is.
It seems to be a MIT Media Lab based project distributed by Sparkfun based on ATMega32u4 micro controller
running Arduino Leonardo firmware.http://www.makeymakey.com/
Ah, yes, I should have linked to makeymakey - thanks for doing that.