Tiny Print for Makerbot Ornament
3
Likes
137
Downloads
693
Views
Published on December 2, 2012
Description
I printed the ornament yesterday, but felt it didn't really look right unless it was printing something, so I whipped up a little build platform that fit on the socket in the ornament and plopped the Holiday Tree onto it.
This is scaled for the "Large" version of the ornament.
This is scaled for the "Large" version of the ornament.
Instructions
Around minute 3 of printing the raft I realized it'd probably have been more efficient to print it with a hole in the middle and stick a bit of filament in the socket. Print the "pegless" version if you have 3mm filament/dowel/etc handy.
License
Tiny Print for Makerbot Ornament by petropixel is licensed under the Attribution - Share Alike - Creative Commons license.
More from petropixel
More from Decor
Asesome! this should be featured imo!