Sign of the Horns Earrings
29
Likes
292
Downloads
1983
Views
Published on December 2, 2012
Derived from
Sign of the Horns
by dietz1
Description
We're going to an Opeth concert tonight. These appropriately death metal earrings are supposed to make the women in my life stars for the night.
This is a scaled down and cropped version of dietz1's Sign of the Horns, intended for use as ear rings.
This is a scaled down and cropped version of dietz1's Sign of the Horns, intended for use as ear rings.
Instructions
Attached STL prints two pairs (left/right hands).
Attached OpenSCAD file loads the original file and scales/cuts if you'd like to change things.
They come out about 32mm from base to fingertip. Use a hot needle to punch a small hole into the middle finger knuckle. Insert earring hooks. Rock out.
I print on a Replicator, 0.15mm layer height, 0 shells, 5% infill, 60/150 feedrates (Sailfish firmware).
Attached OpenSCAD file loads the original file and scales/cuts if you'd like to change things.
They come out about 32mm from base to fingertip. Use a hot needle to punch a small hole into the middle finger knuckle. Insert earring hooks. Rock out.
I print on a Replicator, 0.15mm layer height, 0 shells, 5% infill, 60/150 feedrates (Sailfish firmware).
License
Love it!