Thermistor Protector Clip-on Armor
by wildseyed, published
Heat bed thermistors are one of those step shildren that nobody really knows how to treat well. My hope for this thing is that it will provide both support, and protection for the little guy, and keep him from getting his wires crossed.
Liked Byview all
Give a Shout Out
This version fits the MK1 Beated Bed by Josef Prusa, or any other bed with a nominal thickness of 0.0625 inches. Simply thread the wires of the thermistor through the channels, and clip it onto the side of the bed. Use kapton, or glue to secure it firmly against the bed surface.
For obvious reasons, you will want to print this one in ABS. I turn on the cooling module in Skeinforge, and use a per layer time of 12 seconds, to insure a nice print.