Makergear electronics case lock
4
Likes
67
Downloads
617
Views
Published on December 3, 2012
Description
I just got my M2 and one thing that was bugging me was the case lid kept popping off. I thought about drilling a small hole that I could insert a pin in to prevent it from sliding. But I decided I wanted to find a solution I could print. Here it is.
Instructions
I printed it with 40 percent infill rectilinaer. I had some issue with to much heat in the small nubs but peeled it off and jammed it in holes and it has not moved since.
License
Makergear electronics case lock by Xezerk is licensed under the Attribution - Share Alike - Creative Commons license.
More from Xezerk
More from 3D Printer Accessories
You must be logged in to post a comment.