Cupboard Knob
20
Likes
161
Downloads
689
Views
Published on December 3, 2012
Description
Just a little knob to help you open the doors, drawers and whatever else you need.
The known stick out about an inch or so, and just under an inch wide. They are a simple design that can be modified quickly should you have the need or the Solid Works software.
The known stick out about an inch or so, and just under an inch wide. They are a simple design that can be modified quickly should you have the need or the Solid Works software.
Instructions
I printed mine with low infill and came out alright actually. For the round part I would have the fan on for sure. I had mine all the way and no issues. Goes well with the paper towel holder in the background lol.
Also the hole on the bottom is 4mm diam, and I was able to run the M4 tap nicely but will accommodate anything really around that size and since its plastic you might be able to just screw it in without taping it first.
And oh yes might have to rotate the knob before you slice and print.
Also the hole on the bottom is 4mm diam, and I was able to run the M4 tap nicely but will accommodate anything really around that size and since its plastic you might be able to just screw it in without taping it first.
And oh yes might have to rotate the knob before you slice and print.
You must be logged in to post a comment.