Parametric coat hanger with pins
16
Likes
382
Downloads
1033
Views
Published on December 4, 2012
Description
Wanted to make jsadusk's hanger but with tbuser's pins.
I'm learning my way around OpenSCAD, and this helped.
Eventually I want to make a derivative hanger for my riding pants, so this was a good proof-of-concept.
I'm learning my way around OpenSCAD, and this helped.
Eventually I want to make a derivative hanger for my riding pants, so this was a good proof-of-concept.
Instructions
Snap together with pins!
They're a little tight, so maybe fiddle with the scaling first.
The lower rod overlaps the pin plate a little too much, so I might adjust it at some point.
They're a little tight, so maybe fiddle with the scaling first.
The lower rod overlaps the pin plate a little too much, so I might adjust it at some point.
You must be logged in to post a comment.
License
Parametric coat hanger with pins by chriscrewdson is licensed under the Attribution - Creative Commons license.
More from chriscrewdson
More from Organization
Great idea! I originally tried building the pins into the model and they always broke off along the layers. Didn't even think to print them on their side separately. I'll have to make some more hangers now.
Yeah, I've been on a kick of learning OpenSCAD and found tbuser's pins to be a helpful modification to many models.