Z-axis stabiliser for Mendel Prusa V2
19
Likes
179
Downloads
1651
Views
Published on December 4, 2012
Description
This is the z-stabiliser that came with my first Prusa V2 and is posted for CheeseWeasel. It uses a 608 bearing press fit.
Not my design but works very well.
Not my design but works very well.
Instructions
Print out 2 of these.
Mounts in the middle of the lower side threaded rod and uses another threaded rod between the pair of them.
Mounts in the middle of the lower side threaded rod and uses another threaded rod between the pair of them.
You must be logged in to post a comment.
Wired1
on
December 4, 2012
said:
Yes there is plenty of debate about the merits (or lack) of using these especially when your lead screws aren't perfectly straight as they can actually make the wobble worse. The two printers I have used them on work very well and produce top quality prints but both have very straight lead screws to start with so may do the same without them. In any case I have posted them in response to a request from another member.
thantik
on
December 4, 2012
said:
Do not use these. I'm so sick and tired of posting why, so I'm just going to post the last talk I had about it: https://plus.google.com/108488...
Collections
Things to Make
by NemoKeine
Piezas interesantes para Prusa 2
by jorgepl
Accesorios Prusa
by raulalma
License
Z-axis stabiliser for Mendel Prusa V2 by Wired1 is licensed under the Attribution - Non-Commercial - Share Alike license.
More from Wired1
More from 3D Printer Parts
Thanks Wired1. I'll reconsider their usefulness after the comments below, but thank you for posting this.