Advent Calendar Day 5
by pleppik, published
This model will require some support to print--sorry. I was quite pleased at how well it turned out, since it's just a collection of primitives.
Recent Commentsview all
OOPS!!! I did not see this needed support until it started dumping filament all over the place LOL.Â I downloaded it fro the main page, so I did not see the message here.Â perhaps you can put a little note likeÂ Â
*needs supportÂ Â Â Â
after the entry in the gifts list..Â Â I let it finish anyway.. my support is the filament it dumped in the hole...Â It will take a little cleaning up, but it's on the bottom, the rest of it came out fine.Â Â Â Â I might try to print another one with support, I've never turned on support in slic3r, so now I'm curious about it
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.