ZENDOME Geodesic iPhone 4 Case
16
Likes
391
Downloads
2621
Views
Published on December 4, 2012
Description
A thing to drive your printer mad!
Instructions
i only printed it once as one of my first prints - it was about 1-2mm too small - so resize it! It´s more a WIP Object - it is not really usefull to protect your beloved phone.
The STL has less bridging issues than the rendering!
My last Print with 101% (MAKERWARE) fits but could be a bit smaller - so try perhaps 100,8%
REPLICATOR 2 - Medium Resol. 100% Infill Printing Time 33min.
The STL has less bridging issues than the rendering!
My last Print with 101% (MAKERWARE) fits but could be a bit smaller - so try perhaps 100,8%
REPLICATOR 2 - Medium Resol. 100% Infill Printing Time 33min.
You must be logged in to post a comment.
fullandc
on
January 22, 2013
said:
@michael - No - there is just a difference beetween the rendered model and the printed model - i erased the closed holes fpr the side controls and made them open - you should print it withe the pattern on the building plate - i just turned it for a better view on the pattern! - carsten
michaelladt
on
January 22, 2013
said:
You mentioned bridging... are you printing this the way that it sits in your images?
License
ZENDOME Geodesic iPhone 4 Case by fullandc is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from fullandc
More from Mobile Phone
Nprikkel i erased these holes becaus of bridging problems - you can´t print them! especially the volume hole - except with supports - but you don´t want to do this!
ooh, well i wanted to give it a try anyways!