Loading

razor blade holder

by paradiddle65, published

razor blade holder by paradiddle65 Dec 4, 2012

Thing Info

3595Views 610Downloads Found in Tool Holders & Boxes
Report Thing

Summary

Trapezoidal razor blade holder. Have loose razor blades and no holder? print this!

Instructions

Tabs were added to prevent warping as this design was tested on a reprap printer without a heatted bed. clip them off after print is finished. need screw and nut for rear hole to clamp razor blade into holder. when slicing the STL, make sure to add a few extra shells to prevent the blade from pushing through the top/bottom walls....or just have a high print density

More from Tool Holders & Boxes

view more

Thing Info

3595Views 610Downloads Found in Tool Holders & Boxes
Report Thing

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

Check out the remix (http://www.thingiverse.com/thing:542214), it is much fine tuned and more appropriate for most good quality printers.

razor blade holder (remix)
Top