Shower Screen Hook - parametric
1
Likes
227
Downloads
377
Views
Published on December 5, 2012
Description
I was inspired by takigama's hook, thingiverse.com/thing:28075, so I needed one to fit my shower.
I decided to push myself a bit in my SCAD learning and came up with this. I like the Debug concept to help visualise the bits & pieces.
Now hanging a radio, back brush, face cloth, towel (on outside of course).
The camera didn't cope well with the white plastic...ghost hook?
I decided to push myself a bit in my SCAD learning and came up with this. I like the Debug concept to help visualise the bits & pieces.
Now hanging a radio, back brush, face cloth, towel (on outside of course).
The camera didn't cope well with the white plastic...ghost hook?
Instructions
Adjust parameters to suit your need, render, export STL.
Obviously the heavier the thing you want to hang the more fill you need.
Print with fine layers so curves close up properly, I haven't found the optimal setting yet; but they still hang things ;).
The black printed one is from an earlier iterration.
(I just uploaded v0-1 which has this squared edge in case anyone likes it)
I haven't printed a double ended one yet but no reason it should have any issues.
Obviously the heavier the thing you want to hang the more fill you need.
Print with fine layers so curves close up properly, I haven't found the optimal setting yet; but they still hang things ;).
The black printed one is from an earlier iterration.
(I just uploaded v0-1 which has this squared edge in case anyone likes it)
I haven't printed a double ended one yet but no reason it should have any issues.
License
Shower Screen Hook - parametric by MichaelAtOz is licensed under the Attribution - Non-Commercial - Share Alike license.
More from MichaelAtOz
More from Bathroom
You must be logged in to post a comment.