Up Mini Bed Support
4
Likes
396
Downloads
583
Views
Published on December 5, 2012
Description
I found that my UP! Mini Bed support was slightly too high causing my bed to be high in the center. So I drew UP! an array of supports in slightly different heights to swap out to get it to the right height.
Instructions
The standard height from my stock part I measured was 8mm.
1 - Download all the parts of different heights.
2 - Place them on a bed and print at 0.2mm on fine.
3 - With Perf Board in place measure bow of the print bed. (mine was 0.4mm)
4 - Disassemble printer and remove factory part.
5 - Replace with part of approximately less height.
1 - Download all the parts of different heights.
2 - Place them on a bed and print at 0.2mm on fine.
3 - With Perf Board in place measure bow of the print bed. (mine was 0.4mm)
4 - Disassemble printer and remove factory part.
5 - Replace with part of approximately less height.
License
Up Mini Bed Support by smartin is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from smartin
More from 3D Printer Accessories
You must be logged in to post a comment.