ultimaker pla holder for 30mm reels
4
Likes
81
Downloads
625
Views
Published on December 5, 2012
Description
This thing was made with Tinkercad. Edit it online tinkercad.com/things/1kA85P31VIL
Instructions
works fine for 30mm pla-reels...
very little support is needed for the cranks/lashes
there is a prisma-cut on the bottom of the part to save material and add some extra stiffness...
very little support is needed for the cranks/lashes
there is a prisma-cut on the bottom of the part to save material and add some extra stiffness...
You must be logged in to post a comment.
License
ultimaker pla holder for 30mm reels by romanjurt is licensed under the Attribution - Creative Commons license.
More from romanjurt
More from 3D Printer Accessories
instantly printed after my Faberdashery filmament arrived.. :)thought it would be too small, but it works fine.
its nice that my 5 minute design already safed someone another 5 minutes:)