Tardis Straw Buddy
24
Likes
124
Downloads
1372
Views
Published on December 5, 2012
Derived from
Tardis - Flat Bottom
by gowhitefish
Description
Isn't it annoying when you're in the middle of a fantastic dinner party, discussing bow ties and what you miss most about Gallifrey when your straw slips through the bottom of your glass and into an alternate timeline? We think it is! The Doctor's Straw Buddy will absolutely probably prevent this from happening.
Instructions
It can be tricky to get the sizing right on this one. As uploaded, it's sized for JUMBO straws from Costco's Business Center locations. I haven't been able to find the same straws online.
I suggest printing the first few layers, then stopping the print and testing the hole size against your straw. Adjust and re-print as necessary! Do leave a LITTLE wiggle room, as the center of the vertical shaft has a centered ring that is meant to clamp down a bit on the straw, so if you've adjusted it to JUST fit after a few layers, it won't fit through the finished model.
I suggest printing the first few layers, then stopping the print and testing the hole size against your straw. Adjust and re-print as necessary! Do leave a LITTLE wiggle room, as the center of the vertical shaft has a centered ring that is meant to clamp down a bit on the straw, so if you've adjusted it to JUST fit after a few layers, it won't fit through the finished model.
You must be logged in to post a comment.
License
Tardis Straw Buddy by brucethehoon is licensed under the Attribution - Share Alike - Creative Commons license.
More from brucethehoon
More from Kitchen & Dining
Thank you for your e-mail.
Where did not show whether addressing to you should just mail, but it wrote here.