Spider Mold (cerby's crawlers 04)
by cerberus333, published
as a kid.
Spider was always a favorite.
Now with the magic of 3d printing and oogoo
I get to make creepy rubber spiders with my son!
oogoo - instructables.com/id/How-To-Make-Your-Own-Sugru-Substitute/
Recent Commentsview all
Â That's freaking awesome feedback!
PLA is becoming my only option
a cold garage and ABS are not a good combination!
i guess the wax paper is not the best idea,
i am looking over the old creepy crawler molds
and will be adding those and a few other ideas for molds.
really do appreciate that others are trying the oogoo
i think it's the best thing since 3d printing, makes it affordable
to make molds and then lost wax-metal, plaster, polyester resin (the fiberglass resin) and a slew of other casting
compounds a few steps from 3d printing!
Liked Byview all
Give a Shout Out
I print in ABS for the molds, I have not tested oogoo in PLA.
I used a 10% infill and the finer a slice the better.
Also i have found that acetone wash on the mold cavity
makes a smooth surface which looks great on the castings.
this is a open mold, pack and if desired use a wax paper to
make a smooth flat bottom on the casting
oogoo is silicone caulking (the cheap stuff that smells like vinegar)
mixed with cornstarch.
You must be logged in to post a comment.