Loading

Solidoodle 2 Filament holder

by 3D_CC_design, published

Solidoodle 2 Filament holder by 3D_CC_design Dec 6, 2012

Description

You'll find here a proposition of Solidoodle filament holder.
For me the original position obliged the filament to have a poor curvature.

Recent Comments

view all

I thought this version, but I wanted to put a cristal wall on the side of the printer and I was afraid that interfer.

I made one and I like it a lot. I redrew the outside clamp to catch the bottom of the angle and I am going to make some bushings for the filament spools when I get a chance. Two thumbs up.

More from 3D Printer Accessories

view more

Makes

Liked By

view all

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

For me the original position obliged the filament to have a poor curvature.
And I asked me if it wasn't the origine of feed problem
Since I've done it every thing goes perfectly.

Comments

You must be logged in to post a comment.

wrward on Dec 29, 2012 said:

I made one and I like it a lot. I redrew the outside clamp to catch the bottom of the angle and I am going to make some bushings for the filament spools when I get a chance. Two thumbs up.

3D_CC_design on Dec 31, 2012 said:

I thought this version, but I wanted to put a cristal wall on the side of the printer and I was afraid that interfer.

Top