Santa Sleigh with 8 Reindeer for Lego minifigures
34
Likes
1130
Downloads
4107
Views
Published on December 7, 2012
This thing was Featured on December 7, 2012
Derived from
Santa's sleigh
by CreativeTools
Description
This is a little sleigh I made for a Lego Santa mini figure I have.. the lego bumps are a tiny bit off but will snap in with a little effort.
I also made one without lego bumps for use with the Makerbot man or any other small figures.
I added the shortened Connectors so that it can print on smaller build platforms
I also made one without lego bumps for use with the Makerbot man or any other small figures.
I added the shortened Connectors so that it can print on smaller build platforms
Instructions
Prints without support and just snap together.
I printed mine with an infill of 15% and a layer hight of .20mm with 2 shells..
thought it should print fine with default settings.
The harness to sleigh connection is a bit tight but I did that so it wont fall off once it's connected.
use a pair of pliers to squeese the end to make it fit if nessary..
I used some left over filament to make the reins but you can use string or what ever. it's also fine without reins.
I printed mine with an infill of 15% and a layer hight of .20mm with 2 shells..
thought it should print fine with default settings.
The harness to sleigh connection is a bit tight but I did that so it wont fall off once it's connected.
use a pair of pliers to squeese the end to make it fit if nessary..
I used some left over filament to make the reins but you can use string or what ever. it's also fine without reins.
You must be logged in to post a comment.
License
Santa Sleigh with 8 Reindeer for Lego minifigures by chefmaki is licensed under the Attribution - Share Alike - Creative Commons license.
More from chefmaki
More from Toy & Game Accessories
The bottom of the connector for the reindeer is slightly higher than the reindeer so prints in mid-air.
really?.. maybe my build platform is a bit warped cause it printed fine for me.. I'll fix the file and reload it.