Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
gopro anti jello/rolling shutter mount - multicopter
18
Likes
936
Downloads
2659
Views
Published on December 7, 2012
Description
gopro anti jello mount - multicopter and other STUFF.
this was supposed to be just a prototype, but it worked really well, so i thought id share it.
its a basic V1 , i have to fill in the blanks on its design, i just wanted to see if it the theory worked, to remove camera rolling shutter aka jello. it works well, i will post a youtube video up with its build and results of vibration dampening. :-)
this mount is aimed at being used with my hcopter thingiverse.com/thing:32397
and
thingiverse.com/thing:32640
this was supposed to be just a prototype, but it worked really well, so i thought id share it.
its a basic V1 , i have to fill in the blanks on its design, i just wanted to see if it the theory worked, to remove camera rolling shutter aka jello. it works well, i will post a youtube video up with its build and results of vibration dampening. :-)
this mount is aimed at being used with my hcopter thingiverse.com/thing:32397
and
thingiverse.com/thing:32640
Instructions
new revisions
new outer ring added v1.2 (stiffened up)
this mount is aimed at being used with my hcopter thingiverse.com/thing:32397
and
thingiverse.com/thing:32640
print %100, 0.2 height
assemble as per my youtube video - see links below
its based on m3x6mm approx screws
12mm m3 threaded hex spacers
o-rings about 17mm o/ diameter
parts needed and overview video youtu.be/uZeyHgfuGms
build video youtu.be/izoCp0qehYM
raw onboard footage video youtu.be/WxyDGNWV3Xw
print out
1x part 1
1x part 2
2x part 3
1 base of your choice
1 interface of your choice
parts 4 and 5 are bases
or
print out
1x set one
1x set two
1x base of your choice
1 interface of your choice
new outer ring added v1.2 (stiffened up)
this mount is aimed at being used with my hcopter thingiverse.com/thing:32397
and
thingiverse.com/thing:32640
print %100, 0.2 height
assemble as per my youtube video - see links below
its based on m3x6mm approx screws
12mm m3 threaded hex spacers
o-rings about 17mm o/ diameter
parts needed and overview video youtu.be/uZeyHgfuGms
build video youtu.be/izoCp0qehYM
raw onboard footage video youtu.be/WxyDGNWV3Xw
print out
1x part 1
1x part 2
2x part 3
1 base of your choice
1 interface of your choice
parts 4 and 5 are bases
or
print out
1x set one
1x set two
1x base of your choice
1 interface of your choice
License
gopro anti jello/rolling shutter mount - multicopter by intensewalkera is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from intensewalkera
More from Camera
You must be logged in to post a comment.