Crystal Plate
5
Likes
133
Downloads
500
Views
Published on December 7, 2012
Description
This was created by grade 12 student Scott L. It was just a fun design he was playing with but it could be used to hold some small items.
Instructions
We printed this using a Makerbot Replicator.
Material: Glow In The Dark PLA
Temp: Extruder 200 Bed 0
Infill: 25%
Shells: 2
Support: None
We had some strings hanging from the middle and figure that if we printed at a slightly lower temperature (maybe 190) our results would improve.
Material: Glow In The Dark PLA
Temp: Extruder 200 Bed 0
Infill: 25%
Shells: 2
Support: None
We had some strings hanging from the middle and figure that if we printed at a slightly lower temperature (maybe 190) our results would improve.
License
Crystal Plate by CentaurDesign is licensed under the Attribution - Share Alike - Creative Commons license.
More from CentaurDesign
More from Art
You must be logged in to post a comment.